CSCS Mock Test for Supervisors - Set 8 - Coteca

The beaufort scale is important when working at height externally. What does it measure ?

It measures the load bearing capacity of scaffold

It measures air temperature

It measures wind speed

It measures the load-bearing capacity of a flat roof

Before allowing a lift operation to be carried out, where should you ensure that the sequence of operations is recorded to enable a safe lift ?

In the Crane Hire contracts

In a risk assessment

In approved lifting plan on method statement

In a lifting operation toolbox talk

Where must the number of people who may be carried in a passenger hoist on site be displayed ?

It should be included in the site induction

It should be displayed on a legible notice within the cage of the hoist

It should be displayed on a legible notice in the site welfare area

It should be explained to the hoist operator

When should guard rails be fitted to a working platform ?

Owning if materials are being sorted on a working platform

If it is possible to fall 2 metres

If it is possible to fall through 3 metres

At any height if a fall could result in an injury

On a scaffold, what must be the largest unprotected gap between any guardrail, toe board, barrier or other similar means of protection?

400 mm

600 mm

500 mm

470 mm

Which piece of equipment is used with a cable avoidance tool to detect cables?

Signal generator

Gas detector

Metal detector

Compressor

Which of the following tasks would you expect the Appointed Person for first aid to carry out if someone is injured?

They should provide most of the care normally carried out by a first aider

They should provide all of the care normally carried out by a first aider

They should contact the emergency services

They should only apply splints to broken bones

What should be the capacity of a spillage Bund around a fuel storage tank, in addition to the volume of the tank?

50% (150% of the total content)

30% (130% of the total content)

70% (170% of the total content)

10% (110% of the total content)

Which of the following precautions should be taken to prevent a dumper that is tipping material into an excavation from falling into it?

Dumper drivers are required to judge the distance carefully or be given stop signals by another person

Dumpers should be kept 5m away from the excavation

Stop blocks should be provided parallel to the trench, and appropriate to their vehicles wheel size

Cones or signage should be erected to indicate the safe Tipping Point

In which regulations will you find the details of the welfare facilities that must be provided on a construction site?

The control of substances hazardous to health (COSHH)

Construction (design and management regulations)

The management of health and safety at work regulations

The workplace (health, safety and welfare) regulations

When the construction (design and management) regulations 2015 apply, what must be in place before construction work begins?

The health and safety file

The method statement

A construction Contract agreement

Construction phase plan

If a scaffold is not complete, which of the following actions should be taken by the supervisor?

Display a warning notice and tells operatives to use the scaffold with care

Make sure the scaffolders complete the scaffold

Tell operatives not used the scaffold

Prevent access to the scaffold and add warning signage

A design feature of some airbags used for full assist is a controlled leak rate. If you are using these, what must you ensure about the inflation pump?

It must be electrically powered

It must be switched off from time to time to avoid overinflation

It must run all the time when work is being carried out at height

It must be switched off when the airbags are full

What is the minimum height of the main guard rail on a scaffold ?

875mm

1000mm

950mm

910mm

Which of the following is a significant hazard when excavating alongside a building or structure?

Noise and vibration affecting the occupiers of the building

Undermining or weakening the foundations of the building

Excavating to deeply into soft ground

Damage to the surface finish of a building or structure

Electric welding is about to start on your site. What should be used to protect passers-by from getting arc eye?

Warning signs

Screens

Nothing

Personal protective equipment

The heavy load has been delivered to the site. What is the first thing that should be considered before trying to move it?

How many people are needed to lift a load

How the risk of manual handling could be reduced

How the need to manually lift the load could be avoided

How far load would have to be carried manually

What danger is created by excessive oxygen in a confined space?

False sense of security

Increased flammability of combustible materials

Increase working time inside work area

Increase in breathing rate of workers

How long must you keep inspection records under the construction *design and management) regulations 2015?

At the site until the project is completed

For three months after the inspection has been carried out

For one week on site before sending them to head office

Until the project is completed and then for 3 months

Under the construction design and management regulations 2015, which two of the following must you ensure workers have received before they start working on site?

Details for the designers Plan of Work

Confirmation of their working hours and rest breaks

Details of the clients brief and project expectations

Information on relevant hazards and control measures

A suitable site induction, specific to the work

Question 1 of 20

[email protected]

CITB Test - Practice 8

Click To Start Test

Don’t get confused! Just Fill your details & get quick support for your CSCS Card.

Get on site with right CSCS Card!

Construction Qualification

CITB Test

Services

About Company

NVQ Course

CSCS Card

Resources