CSCS Plumbing Mock Test - 6 - Coteca - CITB Test Revision FREE

If you are drilling a hole to receive a pipe from a radiator, when do you need to wear eye protection?

Only when the drill bit exceeds 20 mm

Only when training overhead

Always, whatever the circumstances

Only when drilling through concrete

If breaking up a cast iron bath, which of the following is the proper way to protect your hearing?

Cotton wool pads

Ear defenders

Rolled up tissue paper

And MP3 player and earphones

You are removing guttering from a large, single Storey, metal framed and cladded building. The job is likely to take all day. What is the most appropriate type of access equipment you could use?

A putlog scaffold

A ladder

A trestle scaffold

A mobile access tower

You have been handling sheet lead. How is some lead most likely to get into your bloodstream?

By not using the correct respirator

By not changing out of your work clothes

By not washing your hands before eating

By not wearing safety goggles

A plumbing permit is required for the replacement of which of the following?

Faucet

Water closet

Water heater

Bathing unit

You Are Required To Take Up A Length Of Floorboard To Install Pipework. Which Of The Following Tools Should You Use? Give One Answer

A hammer and bolster

A hammer and wood chisel

A hammer and screwdriver

A chainsaw

How should bottles be positioned when using oxyacetylene welding equipment ?

Still upside down

Laid on their side

Stood upright

Angled at 45 degrees

How should you dismantle a length of cast iron soil pipe at height?

Crack the pipe at the joint and push it away, make sure the area is clear

Work in pairs, break the length at the collar and remove the pip section

Tie a rope to the pipe and pull the section down. Shout below to warn others

Smashed the pipe into sections using a hammer and remove it piece by Piece

What should you do if you arrive at a job which involves using ladder access to the roof and noticed that the ladder has been painted?

Only use the ladder if it is made of metal

Only use the ladder if it’s made of wood

Not use the ladder and Report the matter to your supervisor

Only use the ladder if wearing rubber soled boots to prevent slipping

Da what is the preferred method of checking for leaks when assembling LPG equipment before use?

Sniff the connections to detect the smell of gas

Test with a lighted match

Listen to hear for escaping gas

Apply leak detection fluid to the connections

What Is It Likely To Mean If The Soil Gives Off A Strange Smell When Digging? Give One Answer

The soil contains a lot of clay

The ground has been used to grow crops in the past

The ground could be contaminated

The soil has been excavated before

Where should a fire extinguisher be if you’re using a blowtorch to joint copper tube and fittings in a domestic property?

Available in the immediate work area

Available only if the property is occupied

There is no need for a fire extinguisher

In your vehicle as long as the doors are locked

What Should You Do When Using A Blowtorch Near To Timber? Give One Answer

Point the flame away from the timber and have a bucket of sand ready to put out the fire

Carry out the work, taking care not to set fire to the timber

Wet the timber first and have a bucket of water handy

Use a non-combustible mat and have a fire extinguisher in the immediate work area

You are working in an occupied Building and have taken up 6 lengths of 3 m floor boarding when you are called away to an urgent job. what should you do?

Tell other work has to be careful while you are away

Permanently fix the floorboards and flooring coverings

Cordon off the work area before leaving the job

Leave the job as it is

If you are carrying out hot works with a bow torch, how long after you finish can you leave the work area?

Just after you finish the work

At least one hour after you finish the work

At least 4 hours after you finish the work

At least 2 hours after you finish the work

While working, you come across a hard, white powdery material that could be asbestos. What should you do?

Dampening material down with water and remove it before carrying out your work

Stop working immediately and tell your supervisor about the material

While wearing respiratory protective equipment remove the material and dispose of it safely

Remove the material come up putting it back after finishing a job

You are asked to join plastic soil pipes in the roof space of a building using a strong smelling hazardous solvent, but you have not been provided with any respiratory protective equipment. What should you do?

Use a dust mask

You stop what you’re doing and get out

Sniff the solvent to see if it has any ill effects on you

Just get on with the job

When working with fiberglass roof insulation, which of the following items of personal protective equipment should you work?

Boots, eye protection and ear defenders

Gloves, respiratory protective equipment and eye protection

Ear defenders, respiratory protective equipment and boots

Barrier cream, eye protection and a face mask

Which One Of These Is True In Relation To The Safe Working Load (Swl) Of Lifting Equipment? Give One Answer

It is provided for guidance only

It is never marked on the equipment but kept with the test certificates

It is the maximum safe working load

It may be exceeded by no more than 25%

Which one of the following items of PPE is designed to protect against infrared radiation damage to the eyes during flame cutting or welding?

Impact rated safety glasses

Eye protection with a tinted of filter lens

Respiratory protective equipment

Reflective vest

Question 1 of 20

[email protected]

CITB Plumbing Mock Test - 6

Click To Start Test

Don’t get confused! Just Fill your details & get quick support for your CSCS Card.

Get on site with right CSCS Card!

Construction Qualification

CITB Test

Services

About Company

NVQ Course

CSCS Card

Resources