CITB Test - Practice 3

Which piece of equipment is used in conjunction with a cable avoidance tool (CAT) to detect cables?

What must be done if a scaffold guard rail needs to be removed temporarily?

Why should you use a RCD with 230 volt tools?

Which of the following is the best way of carrying out chimney work?

When MUST the Health and Safety Executive (HSE) be informed of fatal accidents or dangerous occurrences on-site?

After completing the induction, Mark (new joinee) is given a task that requires him to wear a dust mask but he can’t find one. He should:

Where should an emergency escape route lead?

 If a piece of lifting equipment fails or overturns, under what circumstances must this be reported to the HSE?

Which of the following statements are TRUE?

Which significant hazard do workers face when excavating next to a building or structure?

If a prohibition notice is issued by a Health and Safety Executive (HSE) inspector it means that _________

What restrictions apply to the use of hand signals in directing lifting operations and vehicles on site? Give 2 answers

What precaution should you take if a vehicle load projects outside of the vehicle body?

How should cylinders that contain liquefied petroleum gas (LPG) be stored?

A COSHH assessment tells you how to ______

In what TWO ways might you manage surcharging? Give 2 answers

What item should be regarded as a last resort for a worker’s safety if he/she is working at height?

When must you establish pedestrian routes on site where vehicles are in use?

Which 2 of the following weather conditions might dangerously impact the stability of an excavation?

You need to use inflatable airbags to protect a small area, why is it dangerous to use airbags that are larger than the area that needs to be protected?

When might you use oxygen to enrich an atmosphere?

What precaution must be taken when using mains powered hand tools?

What should you do if you notice workers above a safety net are dropping off-cut materials and debris into the net?

What must be taken into account regarding the use of LMI units?

What MUST be in place on hose joints?